All News | Boards | Chips | Devices | Software | LinuxDevices.com Archive | About | Contact | Subscribe
Follow LinuxGizmos:
Twitter Facebook Pinterest RSS feed
*   get email updates   *

ESP-FLY micro drone kit offers ESP32-S3-based flight control and ESP-NOW support

Apr 30, 2026 — by Giorgio Mendoza 1,965 views

The ESP-FLY DIY Kit is a compact micro drone platform built around the Seeed Studio XIAO ESP32-S3, developed as a collaboration between Seeed Studio and Max Imagination. The kit targets educational and hobbyist use, combining a small airframe with wireless control options and a customizable firmware environment.

The system is delivered as a DIY kit requiring soldering and assembly, resulting in a 67 × 67 × 31 mm drone weighing about 25 g with battery, intended for indoor use and experimentation.

— ADVERTISEMENT —


At the center of the design is the XIAO ESP32-S3 module, based on a dual-core Xtensa LX7 processor running at up to 240 MHz.


ESP-FLY DIY Kit wiring diagram
(click image to enlarge)

The module integrates 2.4 GHz Wi-Fi for direct communication with a mobile device or controller, while also serving as the flight controller, reducing system complexity and size.

Flight stabilization is handled by an onboard MPU6050 six-axis inertial measurement unit, which provides accelerometer and gyroscope data for self-leveling operation typically implemented in an angle mode for controlled indoor environments.


ESP-FLY DIY Kit components
(click image to enlarge)

The flight controller is implemented on a custom four-layer PCB that integrates sensing and motor driving circuitry.

Power comes from four 6×15 mm coreless motors rated at approximately 70,000 RPM, paired with 30 mm tri-blade propellers in a configuration with both clockwise and counterclockwise sets for quadcopter operation.


ESP-FLY DIY Kit side view
(click image to enlarge)

The system is powered by a single-cell 3.7 V, 250 mAh LiPo battery, with a typical flight time of around five minutes depending on usage conditions.

Control is supported through two wireless methods. In Wi-Fi access point mode, the drone can be operated using a mobile application with reported latency in the range of 7 to 25 ms.


ESP-FLY DIY Kit
(click image to enlarge)

Alternatively, ESP-NOW communication allows connection to a compatible controller, extending the control range to approximately 200 meters while providing lower latency compared to standard Wi-Fi.

Documentation and project resources are available through a public GitHub repository, which includes firmware, hardware details, and setup instructions, along with support for ESP-Drone and ESP-FC firmware options and development using ESP-IDF or PlatformIO

Further Information

The ESP-FLY DIY Kit is priced at $59.99 and includes the XIAO ESP32-S3, antenna, IMU/motor driver board, motors, propellers, battery, and 3D-printed frame components, along with basic wiring and assembly accessories.

(advertise here)


PLEASE COMMENT BELOW

Please comment here...